|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#14
November 26th 03, 06:20 PM
|
|||
|
|||
Are you guessing on this, repeating an OWT, or do you have first hand hard data?
Jim "Rob Turk" shared these priceless pearls of wisdom: -You may not want to do that. It works for COM but may not work for -transponders. They work on pretty high frequencies (around 1000MHz) and it -doesn't take much to shield such signals. The composit may not be a problem, -but your paint or even wet conditions may stop the signal from getting out. - -Rob - Jim Weir (A&P/IA, CFI, & other good alphabet soup) VP Eng RST Pres. Cyberchapter EAA Tech. Counselor http://www.rst-engr.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Nav antenna diplexers | Paul Lee | Home Built | 6 | October 30th 03 06:52 AM |
| transponder check? | Russell Duffy | Home Built | 10 | August 15th 03 12:36 AM |
| Foil antenna and carbon fiber | BD5ER | Home Built | 11 | August 6th 03 05:44 AM |
| Antenna Ground Plane Grounding | Fastglasair | Home Built | 1 | July 8th 03 06:21 PM |
| Recommendation for Radio, transponder and Altimeter | Ron Natalie | Home Built | 0 | July 8th 03 04:40 PM |
Threaded Mode