|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
October 31st 16, 09:29 PM
posted to rec.aviation.soaring
|
|||
|
|||
Eccentric cam wing assembly tools
This is a fun thread to read. "How many engineers does it take to ..."?? I say that with many smiley-face emoticons.
FWIW, the simple taper pin that my friend made works 10 times out of 10 with my -29. It's just a delrin pin with a solid handle at 90 degrees to the major axis of the pin. If the wing bushing are misaligned by a few mm, the pin pulls the wings together. If they are misaligned by more than that, it's time to make sure a) the flap handle was in -2 or so and b) the stick was more or less neutral and c) the divebrake handle was at the forward 1/4 or so of travel. P3 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FS: Eccentric Assembly Tools | SteveB_Z5 | Soaring | 18 | December 16th 13 07:30 PM |
| FS: ECCENTRIC ASSEMBLY TOOLs | SteveB_Z5 | Soaring | 17 | March 22nd 13 08:40 PM |
| FS: Eccentric Assembly Tools | SteveB_Z5 | Soaring | 0 | July 28th 12 12:52 AM |
| FS: Eccentric Assembly Tools | SteveB_Z5 | Soaring | 0 | January 21st 12 06:37 PM |
| Wing assembly dollies | Udo | Soaring | 1 | December 2nd 10 03:51 AM |
Threaded Mode