![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Looking to replace the factory/European style tail lights.
Although attractive (??) I think they can be confusing for USA drivers following behind it. Any suggestions for improvement and/or making them more USA "friendly"? And also wiring them for USA vehicles. I have seen several trailers with round L.E.D. replacement tail lights. Source? All suggestions and advice appreciated. Thanks in advance, J4 |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cobra trailer seal replacement--any previous experience? | John Duke | Soaring | 4 | October 5th 15 08:03 PM |
Cheap Cobra Trailer Lights 1998 Trailer on E-bay USA ONLY! | flyingmr2 | Soaring | 4 | November 16th 10 02:11 AM |
Cobra trailer weatherstrip replacement | Larry Goddard | Soaring | 0 | November 25th 09 05:26 AM |
Cobra Trailer Replacement Wheel | Chip Bearden | Soaring | 5 | September 29th 09 08:35 PM |
Cobra Trailer Axel Replacement | Carter | Soaring | 7 | July 7th 04 02:06 PM |