|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
March 8th 17, 06:12 AM
posted to rec.aviation.soaring
|
|||
|
|||
Powerpole assembly
On Tuesday, March 7, 2017 at 7:43:41 PM UTC-8, Tom BravoMike wrote:
raxy... I think I know what you mean. I've been doing this for some time now and actually made two more Andersons today. I usually put the plastic part (sleeve) vertically on the table and push the contacts down with some force with the help of a small screwdriver that catches just the edge of the crimped part, where the cable enters the contact. It clicks in beautifully. But I agree, it's not so obvious. Tom BravoMike Thank you Tom, I find that using a small screwdriver as you described makes it quite easy. The metal crimp seems to be a very tight sliding fit in the plastic housing, and its next to impossible to slide it in just by pushing on the wire. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Saturn IB S-IB Stage Thrust Structure Assembly at Michoud Assembly Facility 6974931.jpg | [email protected] | Aviation Photos | 0 | April 11th 07 02:45 AM |
| Saturn IB S-IB Stage Thrust Structure Assembly at Michoud Assembly Facility 6973027.jpg | [email protected] | Aviation Photos | 0 | April 11th 07 02:45 AM |
| Saturn IB S-IB Stage Assembly at Michoud Assembly Facility 6973449.jpg | [email protected] | Aviation Photos | 0 | April 11th 07 02:43 AM |
| Saturn IB S-IB Stage Assembly at Michoud Assembly Facility 6973447.jpg | [email protected] | Aviation Photos | 0 | April 11th 07 02:43 AM |
| Saturn IB S-IB Stage Assembly at Michoud Assembly Facility 6522687.jpg | [email protected] | Aviation Photos | 0 | April 11th 07 02:43 AM |
Threaded Mode