|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 28th 17, 11:48 PM
posted to rec.aviation.soaring
|
|||
|
|||
Wanted: Wing "Cuffs"
It is a long shot, but I am looking for a set of wing "cuffs". 30 years ago I owned a ASW19 and a Minden trailer. There was a set of aluminum cuffs that slipped over each wing before you loaded it into the trailer. These cuffs slipped about 1/3 to 1/2 the way down the wing. Once the wing root was place on the dolly and rolled into the trailer, the wing was support by the cuff when it was lowered to the floor. I was hoping that someone might have an unused set of these from the "good old days." Yes, I could hammer out a set of these, but I thought I would try asking first. You can contact me at tho*johnson*@*hot*mail.*com (take out the asterisks.) Thanks. TJ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wanted: One-man wing rigger | Bastoune | Soaring | 4 | February 21st 10 04:48 PM |
| Wanted: LH Pw-5 wing | [email protected] | Soaring | 0 | April 12th 09 08:03 AM |
| Spindelberger wing cuffs for tiedown; severe winds | Mitch Polinsky | Soaring | 13 | March 27th 08 12:36 AM |
| WANTED: 2-33 right wing | James D'Andrea | Soaring | 0 | May 27th 07 08:42 PM |
| Wanted L33 - complete right wing | Dave Rolland | Soaring | 0 | August 15th 03 04:35 AM |
Threaded Mode