|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
July 2nd 04, 12:45 AM
|
|||
|
|||
In article ,
"Geoffrey Sinclair" wrote: Corsair propeller diameter 13 feet 4 inches, ground clearance 9.1 inches, engine R-2800-8. The corsair used a 3-blade prop. Why didn't they use a smaller 4-blade prop if ground clearance was such an issue? -- 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| All I Wanted For Christmas Were Inverted Spins | [email protected] | Aerobatics | 3 | December 29th 04 07:40 PM |
| VP-II wings available in Oregon, USA (Or, "How I was coconuted...") | Roberto Waltman | Home Built | 2 | October 29th 04 04:21 PM |
| inverted spin recovery explanation | Alan Wood | Aerobatics | 18 | August 19th 04 03:32 PM |
| Double covering fabric covered wings | [email protected] | Home Built | 9 | May 9th 04 08:39 PM |
| Crooked or Wavy Trailing Edges of Wings and Control Surfaces | Larry Smith | Home Built | 3 | October 24th 03 02:31 AM |
Threaded Mode