|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#13
September 25th 17, 03:25 AM
posted to rec.aviation.soaring
|
|||
|
|||
Nimbus 2B flaps/trim
On Saturday, September 23, 2017 at 8:00:18 PM UTC-6, Aaron Thomson wrote:
After a thorough inspection of the flaps/trim issue, I found that the trim screw was able to bottom out on the flap actuation rod. A simple thin brass washer provided just the right amount separation without losing the trim detents and their ability to hold the trim in place while moving the flap handle through all available settings. Thanks all for the suggestions and wonderful support! STAY SAFE! Aaron Thomson N71TT Nimbus 2B Have fun Aaron!! 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| flaps again | Kobra | Piloting | 107 | January 5th 08 04:31 PM |
| flaps again | Kobra | Owning | 84 | January 5th 08 04:32 AM |
| flaps | Kobra[_4_] | Piloting | 84 | July 16th 07 06:16 PM |
| Nimbus 2 flaps settings | John Orton | Soaring | 0 | May 30th 06 05:40 AM |
| FLAPS | skysailor | Soaring | 36 | September 7th 05 05:28 AM |
Threaded Mode