|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
October 10th 17, 03:56 PM
posted to rec.aviation.soaring
|
|||
|
|||
removing mylars at every annual?
On Tuesday, October 10, 2017 at 9:32:27 AM UTC-4, wrote:
On Tuesday, October 10, 2017 at 9:07:03 AM UTC-4, wrote: The integrity of the hinge can be verified by gently pushing up/down and fore/aft at each hinge post. Lubrication can be done by sticking spray-lube tube under the Mylar at each hinge. JJ I do the same except use a small hypodermic needle to put a small drop of oil in the hinge. Less messy than spray lube for most people. UH yes, hypodermic needle is the way to go! A&Ps who use spray grease on gliders noeed to....not do that. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Removing flux? | Michael Horowitz | Home Built | 6 | July 22nd 10 12:33 PM |
| Removing 2-33A wheel | lanebush | Soaring | 2 | June 27th 09 02:15 PM |
| Removing RTV | John | Home Built | 6 | October 31st 06 10:07 PM |
| Removing Decals | [email protected] | Home Built | 85 | September 9th 05 11:58 PM |
| Removing old antennas | Jay Honeck | Owning | 30 | March 21st 04 04:34 PM |
Threaded Mode