|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
October 10th 17, 11:35 PM
posted to rec.aviation.soaring
|
|||
|
|||
removing mylars at every annual?
On Tuesday, October 10, 2017 at 2:44:15 PM UTC-7, Tom Kelley #711 wrote:
On Tuesday, October 10, 2017 at 3:20:13 PM UTC-6, Darryl Ramm wrote: On Tuesday, October 10, 2017 at 2:10:23 PM UTC-7, krasw wrote: If you have proper sealing, teflon tape under mylar, it is not possible to lubricate hinges. Use upper mylar to prevent water or dust entering hinge. Change everything after 3-5 years and lubricate using grease, not anything that comes out of spray can as it is only cosmetics. Sure you can, if you want to, you stick a large hypodermic needle thought the teflon barrier tape and apply oil from a syringe. Hmmmm.........you might want to check your bottoms! Best. Tom #711 PS glad your not Doctor giving me a shot! Tom when you eventually make it out to CA I can demonstrate how to apply an oil injection. You'll hardly feel it. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Removing flux? | Michael Horowitz | Home Built | 6 | July 22nd 10 12:33 PM |
| Removing 2-33A wheel | lanebush | Soaring | 2 | June 27th 09 02:15 PM |
| Removing RTV | John | Home Built | 6 | October 31st 06 10:07 PM |
| Removing Decals | [email protected] | Home Built | 85 | September 9th 05 11:58 PM |
| Removing old antennas | Jay Honeck | Owning | 30 | March 21st 04 04:34 PM |
Threaded Mode