|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
November 10th 17, 07:58 PM
posted to rec.aviation.soaring
|
|||
|
|||
Grob mechanic in the Midwest?
On Wednesday, November 8, 2017 at 10:44:06 AM UTC-5, wrote:
On Tuesday, November 7, 2017 at 9:02:47 PM UTC-6, Tango Papa IN wrote: There was a complicated AD on the Grob 102 a while back, the wing spar spigot assemblies work. Recently I ran a cross more than one gliders that just hibernating and waiting to be comply with this AD. Grob used to have a service shop in Ohio.. Is anyone from Grob left behind that did this AD before? I am not able to drive to NM and back. Is anyone else successfully did this AD before around Indiana-Ohio-Illinois-Michigan? I appreciate your help! Thanks Gehrlein Products in Waterford, PA is a Sailplane Repair Station. They have been working on composite gliders since the first Libelles were imported and supported by them. The Gehrlein's have worked on my glider and the my club's glider. They do excellent work. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| If you're a mechanic you can relate to this | [email protected] | Piloting | 19 | October 20th 07 01:29 PM |
| If you're a mechanic you can relate to this | [email protected] | Owning | 18 | October 20th 07 01:29 PM |
| If you're a mechanic you can relate to this | [email protected] | Home Built | 18 | October 20th 07 01:29 PM |
| A-65 mechanic question | Michael Horowitz | Home Built | 24 | May 30th 05 11:08 PM |
| Mechanic in MN | [email protected] | Piloting | 2 | March 24th 05 03:09 AM |
Threaded Mode