|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 26th 18, 05:09 AM
posted to rec.aviation.soaring
|
|||
|
|||
Mechanical vario stuck on 5 kts up
Mech vario (PZL, I believe) got stuck on 5kts up. When lift exceeds that (e.g. on tow), needle moves up and then back down to 5. Never goes below 5.
Electric vario that is, to my best knowledge, connected to the same TE source behaves normally. Questions: - Can something like this be caused by an issue in the tubing, etc. or is it more likely an internal issue with the vario itself? - Any particular way to tell? Thanks, -MB 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wanted: Mechanical Vario | Phil Chidekel | Soaring | 2 | March 26th 18 02:38 PM |
| Mechanical Vario FS | pat | Soaring | 0 | November 22nd 12 12:17 AM |
| Mechanical Vario | Jeff Runciman | Soaring | 65 | October 10th 07 09:28 PM |
| Mechanical Vario or not? | Fish | Soaring | 15 | July 2nd 06 02:28 PM |
| Wanted: Used Mechanical Vario | Tim Hanke | Soaring | 0 | May 16th 05 05:35 PM |
Threaded Mode