|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#13
June 4th 18, 01:58 PM
posted to rec.aviation.soaring
|
|||
|
|||
refilling O2 bottles on the road.
Every welding O2 supply house I have been to exchange the cylinder, not re-fill it. It is just so much faster for a welder that needs to get back on the job. This exchange would be only for standard sizes. This may be fine for your glider but in my particular case (Schleicher) I haven't found a welding supply house yet that has the correct (exchange) size for my sleeve. Most glider operations out west can refill for you. You might try medical supply houses.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Road ID - must have | Ben[_6_] | Soaring | 11 | February 19th 15 03:22 AM |
| Seen beside road | George | Aviation Photos | 15 | October 17th 07 09:45 PM |
| One for the road. | Laonork | Piloting | 2 | April 27th 05 11:30 PM |
| looking for consumer review on, um, range extender bottles | Paul kgyy | Piloting | 19 | February 24th 05 02:50 AM |
| USA Roads alternate Road Textures, Not looking like a road map | Simulators | 1 | June 27th 04 10:08 PM | |
Threaded Mode