|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 27th 18, 09:58 PM
posted to rec.aviation.soaring
|
|||
|
|||
PowerFlarm range tool
Hello everyone. I just upgraded my PowerFlarm firmware from 6.42 to version 6.60 this past weekend. After flying I uploaded my .igc file to the PowerFlarm Range Tool to see if anything had changed for the better or worse. Interestingly, the 6.60 generated log file shows zero FLARM data points of any kind in the tool. I can look at the .igc in a text editor and see numerous LFLA records in the file. I know the FLARM was working because I was seeing traffic alerts all day long on my FLARM displays. For grins, I ran a log file generated under FW 6.42 and the Range tool showed many data points. Looking through the log files I see that the 6.42 log file has several encrypted LFLA entries (like LFLA20042502nJMrwj?wwwqyZgn]m#j]HSOIPya) that don't exist in the 6.60 generated log file.
Any ideas? Robert 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PowerFlarm range tool | Mark628CA | Soaring | 2 | November 17th 15 05:24 AM |
| PowerFlarm: 2.7 Vertical Range | [email protected] | Soaring | 8 | April 9th 13 11:27 PM |
| PowerFlarm Range Analysis | Richard[_9_] | Soaring | 0 | March 25th 13 04:43 PM |
| PowerFlarm BRICK range issues - are we alone???? | Mark | Soaring | 79 | October 17th 12 12:17 PM |
| PowerFLarm expected range | [email protected] | Soaring | 6 | August 30th 12 03:43 PM |
Threaded Mode