|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 7th 19, 09:56 PM
posted to rec.aviation.soaring
|
|||
|
|||
When to apply gap seal tape
I am going to be using 3M perfect it followed by WX Block/Seal. Just wondering when in the process i should apply the new gap seals? I think i read that the seals/tape does not stick too well to freshly WX block/sealed surfaces. Should i put them on now and then mask them off, and then do the whole 3M/WX block seal process?
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Solvent for Gap-Seal tape prep | AS | Soaring | 15 | August 15th 17 03:54 PM |
| LS4 aileron gap seal and mylar seal width | Eric Foertsch | Soaring | 8 | May 18th 17 07:50 PM |
| Does part 91 apply outside the USA? | Barry | Piloting | 1 | February 5th 08 09:58 AM |
| Does part 91 apply outside the USA? | Barry | Piloting | 1 | February 5th 08 01:48 AM |
| Teflon gap seal tape... | Marc Ramsey | Soaring | 10 | April 3rd 05 04:35 PM |
Threaded Mode