|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 10th 19, 08:13 PM
posted to rec.aviation.soaring
|
|||
|
|||
Solid Red LED after Flarm update to 6.80
I just updated my PowerFlarm to v6.80 and after the update I'm now getting a solid "red" LED rather than the usual "Green". PowerFlarm feeds Butterfly display and LXNav S80/Oudie 2. All show reception of GPS signal from Flarm and Flarm targets are displayed on all. I've looked at the .TXT file and it indicates update successfully to 6.80 and no obvious (to me) errors.
Does anyone have any suggestions on what is causing the red LED indicating error condition? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Another FLARM update with no notice | Dan Daly[_2_] | Soaring | 1 | September 19th 16 04:30 PM |
| Flarm with Firmware 1.20 update | Robert Fidler[_3_] | Soaring | 49 | January 31st 12 03:40 PM |
| Red Box FLARM update question | Martin Gregorie[_5_] | Soaring | 1 | June 11th 11 10:13 PM |
| FLARM UPDATE? | Stephen Michalik | Soaring | 6 | March 20th 11 04:24 PM |
| FLARM: update to software version 5.00 available | pilot | Soaring | 1 | February 22nd 11 05:27 PM |
Threaded Mode