![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I've been using the center fed dipoles on top of the glare shield of my
Stemme but I just installed a blade antenna on the bottom of the fuselage. My plan is to feed the lower blade antenna with the Flarm A output and the glare shield mounted dipole with the receive-only B input to the PowerFlarm portable.Â* I'll make a few flights and then send logs to Flarm for range analysis.Â* Then I'll swap the A and B inputs and repeat.Â* Whichever shows the best performance will be the final configuration. Any comments or suggestions? -- Dan, 5J |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
second PowerFlarm antenna | Andrzej Kobus | Soaring | 10 | November 2nd 15 03:39 PM |
carbon airframes and Antenna location | Brad[_2_] | Soaring | 2 | July 1st 08 10:42 PM |
Foil Antenna on Carbon Fiber | Dennis Mountains | Home Built | 7 | April 24th 04 12:54 AM |
Mounting GPS/antenna on Carbon panels | Anthony McNicholas | Soaring | 5 | October 26th 03 12:17 PM |
Foil antenna and carbon fiber | BD5ER | Home Built | 11 | August 6th 03 04:44 AM |