If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Looking for a parachute, wing stand and a one-man rigger
On Wed, 05 Feb 2020 22:28:35 -0800, Frank Whiteley wrote:
On Wednesday, February 5, 2020 at 9:44:53 AM UTC-7, Dan Marotta wrote: I don't think drilling holes for safety pins would weaken the uprights very much, but I would drill the holes for the set screws to fit into.Â* Maybe even thread them. 230lbs/panel. Locking pin should be doable. I like Dan's idea - much less chance of losing the pin and the clamp still works at other heights. -- Martin | martin at Gregorie | gregorie dot org |
#12
|
|||
|
|||
Looking for a parachute, wing stand and a one-man rigger
|
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Parachute rigger in Germany | [email protected] | Soaring | 2 | September 10th 18 09:31 AM |
Wing Rigger | Dan Marotta | Soaring | 2 | September 3rd 16 02:54 PM |
Looking for a parachute rigger around New York City... | PAGA | Soaring | 6 | December 24th 15 04:20 PM |
Parachute Rigger near Ionia | Allen Duncan | Soaring | 2 | July 8th 15 12:18 AM |
Looking for a used wing rigger / one man rigger .... | [email protected] | Soaring | 0 | November 6th 13 06:02 PM |