|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
October 21st 03, 12:53 AM
|
|||
|
|||
In article , jeh1941
@bellsouth.net says... So there it is. Don't expect me to defend it. I'm happy to let time be the judge. Fire away! How about a picture of the device? An explanation of how it works? Results of polar measurements confirming the probe results? An explanation of why you think the pressure measurements the probe measures are directly proportional to drag when it is in only 40% of the "flow"? Why you didn't use little pitot tubes (instead of holes in a block) on the drag rake, as Althaus thinks is necessary? -- !Replace DECIMAL.POINT in my e-mail address with just a . to reply directly Eric Greenwell Richland, WA (USA) 
|
|
#2
October 21st 03, 09:29 AM
|
|||
|
|||
|
Screw that...
Where can we buy it  Al "Eric Greenwell" wrote in message .. . In article , jeh1941 @bellsouth.net says... So there it is. Don't expect me to defend it. I'm happy to let time be the judge. Fire away! How about a picture of the device? An explanation of how it works? Results of polar measurements confirming the probe results? An explanation of why you think the pressure measurements the probe measures are directly proportional to drag when it is in only 40% of the "flow"? Why you didn't use little pitot tubes (instead of holes in a block) on the drag rake, as Althaus thinks is necessary? -- !Replace DECIMAL.POINT in my e-mail address with just a . to reply directly Eric Greenwell Richland, WA (USA)
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
