|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
November 17th 04, 08:24 PM
|
|||
|
|||
Bob Johnson wrote:
Reducing the drum size has more effect on torque than I realized. My spreadsheet shows 953 lb-ft for 48", 242 lb-ft for 36" and only 85 lb-ft for 24". What do you think? Maybe this was a private email that escaped onto the newsgroup, but I suggest the torgue should be proportional to diamenter; i.e., the 24" drum torque should be 475 lb-ft. -- Change "netto" to "net" to email me directly Eric Greenwell Washington State USA 
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
