|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
March 7th 05, 07:03 PM
|
|||
|
|||
Slide them over the end of the probe and seat in notch. You can get
any size o rings from Lowe's hardware in the U.S. KP wrote: Hi All Our club G103 has a muli-probe and when you slide the probe in you cannot feel the "O"rings, it basically falls in. It must be leaking, pitot / static / TE?! What is the best way to replace the rings? Were do I get them? Ken (KP) 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Canadian multi reg's | Gary | Piloting | 3 | February 23rd 05 10:11 PM |
| Best Option for Private Pilot to Multi Commercial Instrument Ratings | Hudson Valley Amusement | Instrument Flight Rules | 34 | December 17th 04 10:25 PM |
| Cleaning a 3-way TE probe | Jack Glendening | Soaring | 37 | November 5th 03 07:45 PM |
| Cleaning TE probe - is this a good idea ? | JJ Sinclair | Soaring | 1 | October 7th 03 03:30 PM |
| Broken line to Oil Temperature Probe, Repairable? | rkane33 | Owning | 2 | July 25th 03 04:19 AM |
Hybrid Mode
