![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
|
|||
|
|||
|
On Fri, 7 Jan 2005 12:19:15 -0800, "BTIZ"
wrote: Corky... the point is.. we had a bad tool... and someone knew it.. but never marked it or told anyone else.. it was perfectly good for using to set cables for picnic awnings.. but not for aircraft use. I understand. My thinking was that the original poster was asking if the cheap tool was safe to use. My experience and that of those who've used it and mentioned it here over the years, is that it does produce aircraft quality swages. Corky Scott |
|
#2
|
|||
|
|||
|
I understand. My thinking was that the original poster was asking if
the cheap tool was safe to use. My experience and that of those who've used it and mentioned it here over the years, is that it does produce aircraft quality swages. Corky Scott good deal Corky... we are still recovering from the mechanic being in a rush to get an airplane back in service, that he chose not to drive 80 miles to get his go-nogo tool. The airplane survived the out landing, the pilot also, but we lost two tow pilots who chose not to get back into the airplane after a outside party mechanic said it was good to go. BT |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FS: Papco #600 Flaring Tool | Michael Burton | Home Built | 0 | October 27th 03 06:26 PM |
| canopy breaking tool? | Russell Duffy | Home Built | 33 | October 1st 03 12:39 AM |