|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
October 21st 03, 09:59 PM
|
|||
|
|||
(Gary Gunn) writes:
How much is a marker beacon receiver really used in IFR flying? I'm building a new panel and need to decide if I want to include one or not. Appreciate your input. In Canada, they are not used at all: the first time I heard mine go off was when I overflew Albany NY at altitude during a flight in the U.S. Go to www.myairplane.com and look at the approaches for airports you might like to visit some day. Note that you can get an audio panel with the marker beacons built in, so it's not a big extra cost or a lot of extra panel space. All the best, David 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TKM MB75 Marker Beacon Receiver | Darrel Toepfer | Home Built | 0 | August 18th 04 11:31 PM |
| Foil Antenna on Carbon Fiber | Dennis Mountains | Home Built | 7 | April 24th 04 01:54 AM |
| KR-21 marker beacon pinout? | JFLEISC | Home Built | 0 | March 17th 04 11:46 PM |
| RF interference issue again (esp. for E Drucker and Jim Weir and other RF wizards) | Snowbird | Home Built | 78 | December 3rd 03 10:10 PM |
| Marker Beacon Antenna - Paging Jim Weir. | Bart D. Hull | Home Built | 1 | November 27th 03 11:31 PM |
Threaded Mode