![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Tony wrote:
If the engines were not turbocharged I'd be betting improper leaning for the density altitude would have a factor, but have no experience at all with turbocharged engines. FWIW, the mixture of my turbo-normalized Bonanza is not leaned for a high-density airport take off. Doing so results in higher than desired CHT and turbo-inlet temperatures (TIT), which is not a healthy scenario for the engine that is delivering full horsepower. By no means am I a turbo expert, but had the Aerostar in this accident been equipped with turbocharged engines, I would be surprised to learn that it would need to be leaned for a density altitude take-off of only 4,000 feet. -- Peter |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I want to build the most EVIL plane EVER !!! | Eliot Coweye | Home Built | 237 | February 13th 06 04:55 AM |
| Most reliable homebuilt helicopter? | tom pettit | Home Built | 35 | September 29th 05 03:24 PM |
| Mini-500 Accident Analysis | Dennis Fetters | Rotorcraft | 16 | September 3rd 05 12:35 PM |
| NTSB Reports | Tony | Piloting | 2 | August 16th 05 03:28 AM |
| Learning from NTSB reports | Roger Long | Piloting | 23 | December 1st 03 03:15 PM |