|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
September 3rd 07, 08:08 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Making plastic parts
Acyrilic casting resin - arts and crafts stuff...
Jerry Wass wrote: Hmmm--I wonder how they get those little spiders,Scorpions, medalions etc inside those polished acrylic deskweights???Jerry Lou wrote: Does anyone know of a material that starts as a liquid, but hardens as a platic? I want to make some custom plastic parts for my plane (no not for the structure) that will require making a mold and then pouring in the liquid. Lou 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pirep on replacing interior plastic parts | [email protected] | Owning | 1 | April 12th 05 06:06 AM |
| Plastic Interior Parts? | Mike Spera | Owning | 16 | March 30th 05 09:35 PM |
| Repairing Plastic Interior Parts of 40-year-old Aircraft | jls | Home Built | 6 | December 7th 04 11:04 PM |
| 172 plastic interior parts | G.R. Patterson III | Owning | 9 | May 28th 04 11:28 PM |
| Cessna 172 interior plastic parts | [email protected] | Piloting | 3 | February 11th 04 05:19 AM |
Threaded Mode