LS7 Main Wheel / Landing Gear question

Thanks JJ, but the wheel is actually off-center in the direction of the wider spacer. Using the smaller one in its place would not seem to work.


Check the spacers that slide over axle, usually one wide, one slim.............bet you got them reversed.

JJ

On Jun 5, 6:30*am, Gianni Isotope wrote:
Thanks JJ, but the wheel is actually off-center in the direction of the wider spacer.
*Using the smaller one in its place would not seem to work.

That being the case, then it might be that the wheel is mounted off-
center at the factory, and that's just the way it is. It is very
typical among HP-series operators to shift the wheel 1/2" or so off-
center to accommodate a disk brake system. Such offsets seem to make
no discernible difference to the takeoff, landing, or rollout
characteristics.

Thanks, Bob K.