![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
|
|||
|
|||
|
On Thursday, December 12, 2013 3:02:28 PM UTC-5, Steve Leonard wrote:
On Thursday, December 12, 2013 12:01:11 PM UTC-6, Soartech wrote: Dave, what is the "correct" type of grease to use? Opinions vary. Of course, this is RAS ;-) Some sort of white lithium grease it probably best. I used to use white lithium... Advantage: really easy to see if its clean. Disadvantage: less "slippery" than some other greases, does tend to cake up. I have used just plain vaseline, and have also seen it act more like glue than grease... Right, not recommended. I'm not sure what I'm using now: Lange provides good grease in a big syringe in the pouch that holds the pins. It lasted for assemblies for 900 hours of flying, then they gave me a new syringe. I'll make sure its provided to you with your new Antares. The synthetics like Superlube are really good. See ya, Dave "YO electric" |
|
#2
|
|||
|
|||
|
Thanks. I've been using Permatex white lithium grease. Back to the gym this winter.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FS: ECCENTRIC ASSEMBLY TOOLs | SteveB_Z5 | Soaring | 17 | March 22nd 13 08:40 PM |
| FS: Eccentric Assembly Tools | SteveB_Z5 | Soaring | 0 | July 28th 12 12:52 AM |
| FS: Eccentric Assembly Tools | SteveB_Z5 | Soaring | 0 | January 21st 12 06:37 PM |
| Saturn IB S-IB Stage Thrust Structure Assembly at Michoud Assembly Facility 6974931.jpg | [email protected] | Aviation Photos | 0 | April 11th 07 03:45 AM |
| Saturn IB S-IB Stage Thrust Structure Assembly at Michoud Assembly Facility 6973027.jpg | [email protected] | Aviation Photos | 0 | April 11th 07 03:45 AM |