|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
November 20th 03, 12:48 AM
|
|||
|
|||
On Wed, 19 Nov 2003 15:57:07 -0600, "MJC" wrote:
Don't do it. Liquid Nail (brand name) is not strong enough in the ways that count for spars. There's a reason why 30 minute (or longer) epoxy has been used for this purpose for so long. I'd give you a smart ass answer too but I can't think of one at the moment. MJC MJC, A question like that does not deserve even a smart ass answer. O-ring 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Marske spar workshop | Marske Flying Wings | Home Built | 0 | October 14th 03 05:53 PM |
| FS: Wing spar angle extrusions | Bob Kuykendall | Home Built | 0 | September 25th 03 09:23 PM |
| Carbon Spar design and construction workshop | Marske Flying Wings | Home Built | 0 | September 18th 03 06:47 PM |
| Wood questions - Public Lumber Company, determining species at the lumberyard | Corrie | Home Built | 17 | September 17th 03 07:51 PM |
Hybrid Mode
