|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
November 29th 03, 03:37 AM
|
|||
|
|||
On 28 Nov 2003 04:02 PM, Peter Dohm posted the following:
I don't know about Paintshop Pro, but Autocad used to be available for the Mac - although they might sell it to you all over again. Autodesk dropped Mac support a long time ago, I think back around version 12, so it wouldn't even run in OSX. ---------------------------------------------------- Del Rawlins- Remove _kills_spammers_ to reply via email. Unofficial Bearhawk FAQ website: http://www.rawlinsbrothers.org/bhfaq/ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Manifold pressure gauge problem | Dave Russell | Aerobatics | 3 | January 29th 04 04:46 AM |
| RF interference issue again (esp. for E Drucker and Jim Weir and other RF wizards) | Snowbird | Home Built | 78 | December 3rd 03 10:10 PM |
| FA - Garmin AT CNX-80 and MX20 | B2431 | Home Built | 0 | November 13th 03 04:43 AM |
| Can we talk about the Randolph problem? | Michael Horowitz | Home Built | 5 | October 30th 03 05:44 PM |
| KY97A Problem | Continental Bill | Home Built | 1 | October 20th 03 10:08 PM |
Hybrid Mode
