|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 10th 03, 05:53 PM
|
|||
|
|||
Rubber Bushing Replacement
I have a 0200A Continental engine with total hrs (600hrs) and thinking maybe I
should change out the rubber engine mount bushings only because they have been on the plane for 25+ years. They look fine but maybe a little sag on the bottom ones. Is this usually just an eye ball assessment or a "must do" item based on #years on the plane? Thanks.Larry 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| piston connecting rod bolt replacement | Dick | Home Built | 5 | October 7th 03 03:34 PM |
Threaded Mode