|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 11th 03, 07:14 PM
|
|||
|
|||
help on ad9830 programing
hi
i have read ad9830 dds ic datasheet, but i have steel problem how i should program it, for example i want to use pararel port for interfacing , and for example want 3.1MHZ on out put, how i should use D0 to D15 and A0,A1,A2? should i use both freq reg ( 0,1) and all 4 phase reg ? or one is enouth? any help would be most appreciated thanks payam 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode