![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I'm not convinced that he is going to need a new prop and engine teardown.
It sure looked like he stopped the prop before touchdown I tried watching the clip again but couldn't view it. IIRC the prop was spinning when he landed - I don't know if that's considered sudden stoppage. It looked like all three blades got bent up pretty good. As far as the engine, if the prop was just windmilling and the engine wasn't making any power, maybe it wouldn't need a teardown. I'd assume insurance would cover it minus any deductible. That reminds me of why I like the Piper gear system better. If there's any loss of system pressure the gear free-falls. |
#2
|
|||
|
|||
![]() |
#3
|
|||
|
|||
![]()
Not sure why he ran away from the plane so fast. If it were my plane
I'd be right there, making sure an overzealous firefighter didn't do anything stupid, like spray it with a high pressure hose. -Robert |
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Saratoga Gear Retract Problem | Yahoo! News | Owning | 16 | November 29th 05 11:17 PM |
Jet engines vs. leaf blowers | 01-- Zero One | Soaring | 6 | September 8th 05 01:59 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 05:23 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 03:52 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 06:24 AM |