Winter mechanical vario reading high

wrote:
Hi,
You are assuming the identified problem is real. It could be something
else. You are using this problem so you can use the solution you have.
Adding paint is just convenient. Send it to Winter.
S6

Thanks for the reply. However I better check the plumbing myself
and will probably try to zero it myself. If the plumbing is bad,
Winter won't find anything wrong and will have to charge me for the
diagnosis and shipping, and I'll have no instrument while I'm waiting.

However, I don't think I will try adding paint at this time. I may
later
if other solutions fail, or I may send it to Winter.

Alan

"Roger Druce" wrote in message
u...

Don't give the job to your local club member-gorrilla!


But what if it happens that ** I ** am the local club member-gorilla?

Ah well, I may be a little ham-handed, but I do have opposable
thumbs, just like the rest of you.

Seriously, thank you very much for the advice.

Alan

Some years ago in a posting about the same topic, somebody (I do not
remember the name) recommended:
"If your VSI reads too high, extend the spoilers a little bit, untill your
vario shows the expected value."
;-)
Best regards
Walter

"Walter Kronester" wrote in message
...
Some years ago in a posting about the same topic, somebody (I do not
remember the name) recommended:
"If your VSI reads too high, extend the spoilers a little bit, untill your
vario shows the expected value."
;-)
Best regards
Walter

For some reason, even full extension doesn't get me to the expected value
when checking the panel, pre-flight.

Tim Ward