|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 30th 06, 11:52 PM
posted to rec.aviation.restoration
|
|||
|
|||
Welding question -
In preparation for doing some simple OA welding on a rudder, I've been
practicing on some 4130 scrap. Since there is filler where it's not structurally important, I"ve been filing the excess material. All except one and it's as hard as if I were trying to file stainless. Is this an indication that I was using an oxidizing flame on that sample? - MIke 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aluminum welding | Ernest Christley | Home Built | 5 | April 24th 06 11:47 AM |
| Lyc. O-360 cylinder question | JB | Owning | 13 | November 27th 04 09:32 PM |
| A question on Airworthiness Inspection | Dave S | Home Built | 1 | August 10th 04 05:07 AM |
| TIG welding video? | Russell Duffy | Home Built | 3 | October 6th 03 05:55 AM |
| Partnership Question | Harry Gordon | Owning | 4 | August 16th 03 11:23 PM |
Threaded Mode