![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]() "T o d d P a t t i s t" wrote Pull the bag out, squeeze out air, close it, knead the two components together, use a pencil to push all the mixed epoxy to one corner, snip off that corner and apply like a frosting bag - the bigger the snipped corner the more you can apply quickly. Tiny jobs use tiny snips. Nice trick! I can guarantee that I will be using that method in the future! g Thanks! -- Jim in NC |
#12
|
|||
|
|||
![]()
Orval Fairbairn wrote:
In article .com, "steveukman" wrote: I am seeking advice about mixing and storing epoxy. This also works on epoxy primers, and, to a limited extent, 2-part polyurethane paints. I would imagine that it also works on fuel tank sealants. Freezing slows down the chemical reaction and greatly extends pot life. Its been a while since I took organic chem, but I seem to remember a rule of thumb that said organic reactions slow down by half every 2 degrees C lower you take them. |
#13
|
|||
|
|||
![]() |
#14
|
|||
|
|||
![]()
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1 Dennis Johnson wrote: "steveukman" wrote in message oups.com... I am seeking advice about mixing and storing epoxy. For 15 bucks you can buy an electronic scale on EBay with an accuracy of a tenth of a gram that will allow you to mix tiny batches of epoxy. Personally, I wouldn't feel comfortable with using previously frozen, mixed epoxy for an airplane unless the epoxy manufacturer okayed it, but I'm a coward. My advice is to get an accurate scale and only mix as much as you need. Remember, prepreg is purchased frozen & kept in a cooler until needed. -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.1 (GNU/Linux) iD8DBQFE+JadpxCQXwV2bJARAoZNAKCKBSpwiyfp1kqy6PACMw 3SYMGlugCgpJ2p rN2zDFhC5XKnxaYb5hlIdDU= =dNQi -----END PGP SIGNATURE----- |
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Epoxy for Fuel Tanks | Doug Palmer | Home Built | 1 | April 12th 06 02:53 AM |
Dupont Corlar epoxy primer? | [email protected] | Home Built | 1 | May 18th 05 07:30 PM |
Epoxy Bonding to Aluminum and Magnesium | Ryan Young | Home Built | 25 | September 16th 04 02:45 AM |
Question about epoxy resin chemistry.. | Chris | Home Built | 26 | April 15th 04 12:55 AM |