If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
"Eric Greenwell" wrote in message ... Bill Daniels wrote: Most vario's have a time constant of about 2-3 seconds or more. I put a bunch of different varios on a test bench last winter and found some were as bad as 11 seconds. The average 45 degree bank thermalling turn takes about 13 - 14 seconds Yikes! I don't know what you are flying, but it takes my ASH 26 about 27 seconds to make one turn (50 kts IAS, 8000' msl, 8.2 lb/sq ft wing loading). That's measured from a flight trace. My ASW 20 was a little quicker, flying at 7.5 lb/sq ft, but nothing like 14 seconds. Should be 17secs. Try your flavor. http://www.soarcsa.org/thinking_page...calculator.htm Frank Whiteley |
#22
|
|||
|
|||
Try your flavor.
http://www.soarcsa.org/thinking_page...urn_radius_cal culator.htm Frank, the CSA website is truly impressive! Well done to you and your team. Question though, where is the link to the Thinking Pages section? TIA. Jim Vincent N483SZ illspam |
#23
|
|||
|
|||
"Jim Vincent" wrote in message ... Try your flavor. http://www.soarcsa.org/thinking_page...urn_radius_cal culator.htm Frank, the CSA website is truly impressive! Well done to you and your team. Question though, where is the link to the Thinking Pages section? TIA. Jim Vincent N483SZ illspam No such link as it wasn't quite fleshed out. We'll add one though. Frank |
#24
|
|||
|
|||
At 8000' 50kts IAS = 58kts TAS, so 27 seconds would
correspond to a 40 degree bank angle. Wing loading is only relegant to the degree that it affects stall speed. The only relevant variables for turn radius are ture airspeed and bank angle - assuming you are flying in an unaccelerated condition. Of course you can make a real fast circle if you spin it... 9B At 23:30 18 October 2004, F.L. Whiteley wrote: 'Eric Greenwell' wrote in message ... Bill Daniels wrote: Most vario's have a time constant of about 2-3 seconds or more. I put a bunch of different varios on a test bench last winter and found some were as bad as 11 seconds. The average 45 degree bank thermalling turn takes about 13 - 14 seconds Yikes! I don't know what you are flying, but it takes my ASH 26 about 27 seconds to make one turn (50 kts IAS, 8000' msl, 8.2 lb/sq ft wing loading). That's measured from a flight trace. My ASW 20 was a little quicker, flying at 7.5 lb/sq ft, but nothing like 14 seconds. Should be 17secs. Try your flavor. http://www.soarcsa.org/thinking_page...adius/turn_rad ius_calculator.htm Frank Whiteley |
#25
|
|||
|
|||
Bill Daniels wrote:
"Eric Greenwell" wrote in message ... Yikes! I don't know what you are flying, but it takes my ASH 26 about 27 seconds to make one turn (50 kts IAS, 8000' msl, 8.2 lb/sq ft wing loading). That's measured from a flight trace. My ASW 20 was a little quicker, flying at 7.5 lb/sq ft, but nothing like 14 seconds. You might re-check your bank angle and your static port position error. 27 seconds seems too long. Using Frank's calculator, 55 knots @ 35 degrees gives about the right diameter and time. I don't know the density altitude that day, but the speed sounds a little low. The IAS was likely 50 knots, where I usually thermal when empty. Looking at a contest flight, the thermal I measured then plugged into the calculator gave 65 knots @ 40 degrees to get the right diameter and time (27 seconds). That was a 9800' msl on a warm summer day, so the speed seems about right; also, I was flying with water. Next time I thermal, which might be 5 months from now, I'll have to concentrate on bank angle more and redo the measurements. I generally find myself flying at steeper bank angles than most pilots, except at contests with good pilots, where it's about the same. Maybe the instrument mounting holes on our panels aren't quite at 45 degrees... But, what I was getting around to saying is your comment - The average 45 degree bank thermalling turn takes about 13 - 14 seconds may be true for you, but not most pilots, based on my observations in sport and contest flying, where 22+ seconds is typical. Maybe you meant your average turn? -- Change "netto" to "net" to email me directly Eric Greenwell Washington State USA |
#26
|
|||
|
|||
"Eric Greenwell" wrote in message ... But, what I was getting around to saying is your comment - The average 45 degree bank thermalling turn takes about 13 - 14 seconds may be true for you, but not most pilots, based on my observations in sport and contest flying, where 22+ seconds is typical. Maybe you meant your average turn? Nope, I meant my standard thermalling turn in the Nimbus is 14 seconds, 45 degrees and 45 MPH. If the core is small, I'll tighten up to a 60 degree bank and 48mph. Ballast will, of course, bump those numbers up a little. Eric, I think your turns are way too shallow and fast to make use of the strong cores. Bill Daniels |
#27
|
|||
|
|||
Wow, I really appreciate all the comments on thermalling. It is
amazing how much thought and calculations go into this sport although not all agree on the solution. Reminds me of all the advice I got on take-off. It was all good but also different. It would seem logical if you are in a close circle with another glider that reducing the bank angle is the safer technique. That said if you are not in danger of conflict then increasing the bank angle seems to follow what I was taught and what I have read. The last flight of this year I tried water and that brought out a lot of flaws in my termalling technique. Controlling speed and flying through thermals were a problem. It was like learning all over again, although when I looked at the trace after the flight I was impressed with my average speed. I think using smoother and less abrupt changes is something I need to work on and some of the techniques mentioned here seem to enforce that. |
#28
|
|||
|
|||
But, what I was getting around to saying is your comment - The average 45 degree bank thermalling turn takes about 13 - 14 seconds may be true for you, but not most pilots, based on my observations in sport and contest flying, where 22+ seconds is typical. Maybe you meant your average turn? Nope, I meant my standard thermalling turn in the Nimbus is 14 seconds, 45 degrees and 45 MPH. If the core is small, I'll tighten up to a 60 degree bank and 48mph. Ballast will, of course, bump those numbers up a little. Eric, I think your turns are way too shallow and fast to make use of the strong cores. Bill Daniels Eric &Bill If a stall speed of a glider is 36 kt at a wing loading of 6 lb/sq/ft in a 45 deg. it will be about 44 kt and at a 60 deg bank it will 50kt. With a loading of 9lb/sq/ft the stall speed will be 44kt at a 45 deg bank it will be 53kt and at a 60 deg bank it will be 61 kt. I do not know what your respective wing loading are but both of you could be right. It is more beneficial to turn tighter with a lighter wing loading , then it is with a heavier wing loading. Regards Udo |
#29
|
|||
|
|||
Udo Rumpf wrote:
Eric, I think your turns are way too shallow and fast to make use of the strong cores. Bill Daniels You might be right, but I'm not routinely outclimbed by other pilots wherever I fly, even by US World team members, so experience suggests I'm not too far off the mark. I do try tighter banking occasionally, and sometimes it helps, but it usually not, so the 40 degree bank is what I normally end up using. Perhaps you are circling more tightly than needed, your thermals are much smaller than the ones I encounter, or as Udo suggests, it's the wing loading difference. Or all items... It would be interesting to look at the circling times of good contest pilots using contest flight files, or perhaps the OLC files. Circle time (our primary parameter in the discussion) and circle diameter can be obtained directly from the flight trace, the true airspeed can be determined by noting the highest and lowest ground speeds during the circle and taking the average. These can be plugged into Frank's web calculator to get the bank angle. -- Change "netto" to "net" to email me directly Eric Greenwell Washington State USA |
#30
|
|||
|
|||
Eric Greenwell wrote:
Udo Rumpf wrote: Eric, I think your turns are way too shallow and fast to make use of the strong cores. Bill Daniels Ooops! The above was written by Bill, not Udo, as I accidentally replied to the wrong posting. -- Change "netto" to "net" to email me directly Eric Greenwell Washington State USA |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Themi thermal locator | John Jones | Soaring | 5 | April 30th 04 04:16 AM |
For Auction: Thermal Imaging Camera - One Day Left | sell2all | Rotorcraft | 0 | April 29th 04 08:29 PM |
For Auction: Thermal Imaging Camera - One Day Left | sell2all | Military Aviation | 0 | April 29th 04 06:45 PM |
Spin on thermal entry - how-to | Bill Daniels | Soaring | 0 | January 29th 04 05:43 PM |
Thermal to Wave contact! | C.Fleming | Soaring | 1 | January 21st 04 01:54 PM |