![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
![]()
I used the PowerFlarm config tool v1.2.5 because that is what came up on a search for it. LXnav just seems to be advertising on it?
|
#22
|
|||
|
|||
![]()
Yes, it does. Comes up when I power the unit on.
|
#23
|
|||
|
|||
![]()
I am picking up ADS-B traffic, with or without the transponder set to ON. My PowerFlarm has a mark on the top of the case that has ADS-B marked.
|
#24
|
|||
|
|||
![]()
Thanks. I will try that next, in lieu of better advice.
Rob “4D” |
#25
|
|||
|
|||
![]()
On Tuesday, June 2, 2020 at 3:33:57 PM UTC-7, Rob Cluxton wrote:
Thanks. I will try that next, in lieu of better advice. Rob “4D” https://flarm.com/support/tools-software/ Richard www.craggyaero.com |
#26
|
|||
|
|||
![]()
Booting it up with an empty USB stick worked! I then cleared the stick, again, and loaded one more time with the config file. All is well...
Thanks, Rob |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Flarm picking up my transponder | Rob Cluxton[_2_] | Soaring | 31 | May 7th 20 12:17 PM |
PowerFlarm “Own Transponder Detection" Rate | John Carlyle | Soaring | 18 | July 21st 17 05:59 PM |
PowerFLARM Transponder Alert Size | John Carlyle | Soaring | 2 | May 6th 13 04:33 PM |
PowerFLARM Brick and PowerFLARM Remote Display Manuals Available | Paul Remde | Soaring | 30 | May 25th 12 11:58 PM |
OSH traffic picking up | Jim Burns | Piloting | 16 | July 22nd 06 08:48 PM |