![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Interesting home-brewed investigation into the drag between the fin-type and rod-type transponder antenna by one of our friends in The Netherlands.
Seems like the fin type antenna - unless mounted exactly on the centerline of the glider, where the flow is expected to be parallel - may produce a lot of turbulence and drag. https://www.youtube.com/watch?v=8ii_...ature=emb_logo Take a look at this type of antennae installed under the belly of power planes. In most cases, you will find one side (typically the right side due to the prop-wash)) caked with soot and grime while the other side is relatively clean. Would be interesting to quantify the drag this causes and the extra fuel burn over the lifetime of the plane. I bet most power-pilots don't even know/think about it. Uli 'AS' |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Antennae | John McCullagh[_2_] | Soaring | 34 | July 23rd 19 08:50 PM |
VOR Antennae Installation | guynoir | Home Built | 1 | November 8th 06 03:37 AM |
Which antennae please? | Robert Loer | Home Built | 1 | October 27th 04 11:55 PM |
Drag - Anti/Drag Wires | log | Home Built | 3 | August 28th 03 07:06 AM |
Drag of LS3 compared LS3a. | Peter Warburton | Soaring | 0 | August 18th 03 06:59 AM |