If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Refinishing: Who has tried a shortcut?
Hello All
There has been quite a bit on refinishing on RAS recently. Most people advocate that when gel-coat starts cracking up, it is essential to remove it ALL. Does anybody out their own a ship which was refinished without removing all the gel-coat? What is the service history of these gliders? If the RAS collective are right on this, I suspect that there will be a number of hard luck stories out there from people who have discovered this the hard way. Personally, I know of many ships that have been resprayed. I suspect many of them were not sanded down to glass and those that I see around don't look too shabby. I can't help feeling that there is another side to this story. I used to own a share in Nimbus II that was resprayed with poly urethane paint (Glasflurit "Durothane K" they claimed) by the previous owner. I don't know what condition the gel was prior to painting, or how much gel was removed. There was no obvious sign of a primer layer under the paint either. However, I had it for 10 years and the poly finish was perfect when I sold. The only problem we had with it was doing minor repairs. It was very difficult to re-spray a small area without a visible brownish "water mark" where the new and old paint met. But we just lived with a few water marks. We used to polish the finish with a "liquid polymer" car polish. (Why not, car polish on car paint, works on hundreds of thousands of cars ..) Can't say we had a problems from that, except that I suspect it may be have had something to do with the water marks. For small dings we filled with body filler and/or high build poly urethane primer, then resprayed with aerosol lacker. After sanding and polishing, the results were pretty neat. For bigger repairs we masked off and resprayed an entire "panel" with the original poly urethane, primer and top coat. After my experiences I would never pay anybody to refinish a glider with gel coat. If I ever bought a new glider, and I had a choice, I would order a urethane finish. Now I have bought a share in an LS3a that has the original gel coat finish over most of the surface. We keep it polished with a "silicon free" glazing wax. But it is pretty cracked up and I am wondering how it is going to become a urethane finish. Who has been down this road before and tried a "short cut"? Regards Ian |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Commercial Glider refinishing book | Martin Carolan | Soaring | 0 | December 15th 03 09:41 AM |
REFINISHING | Ventus B | Soaring | 32 | December 3rd 03 10:14 PM |
Older glass glider refinishing question | Gus Rasch | Soaring | 6 | November 10th 03 12:18 AM |
Refinishing Your Aircraft (now in Oregon) | aerocomposites | Home Built | 0 | September 24th 03 05:29 AM |
Tracon II Shortcut key for "THEN" | Jack Frost | Simulators | 0 | August 17th 03 02:54 PM |