|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 13th 04, 02:45 PM
|
|||
|
|||
ELECTRO-PLATING
I used to do a lot of plating (about 40 years ago) on various parts to
prevent oxidation. I would now like to chrome or silver-plate some components on my ultra-light engine.Please forgive an Old Mans memory, but I have forgotten what kind of acid to use in the plating solution. I would sure appreciate any help. Thank you Chuck 
|
|
#2
December 14th 04, 12:44 AM
|
|||
|
|||
|
Check out this link:
http://www.focuser.com/atm/anodize/anodize.html See if it brings back any memories.... "Chuck" wrote in message ... I used to do a lot of plating (about 40 years ago) on various parts to prevent oxidation. I would now like to chrome or silver-plate some components on my ultra-light engine.Please forgive an Old Mans memory, but I have forgotten what kind of acid to use in the plating solution. I would sure appreciate any help. Thank you Chuck
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Epoxy Bonding to Aluminum and Magnesium | Ryan Young | Home Built | 25 | September 16th 04 02:45 AM |
Linear Mode
