If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Mike, if your anywhere near Philadelphia, I sugggest going to Airtex and
visiting them. I did prior to my work. You can check out all their products. Sandy Mustard Mike Spera wrote: Thanks to the respondents. Useful information. To the person who seemed convinced that I was going the Airtex route because I was "spooked" by the burn test regs, that is not exactly true. Whether or not my plane is subject to the reg is unimportant. The fact that the general A&P and FAA community is confused IS the issue. In my case, I would rather have the paperwork than not. I know that some auto shops have been through this. So, I am not prejudiced against going that route. |
|
Thread Tools | |
Display Modes | |
|
|