If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Becker AR4201 transmit volume low
On Friday, July 19, 2019 at 9:55:34 AM UTC-6, Dan Daly wrote:
On Friday, July 19, 2019 at 11:45:19 AM UTC-4, John Foster wrote: I tried adjusting the mic sensitivity in service mode all the way up to 63, but it didn’t seem to make any difference. I have the wiring harness from Wings and Wheels. How would I go about switching pin 5 with pin 18? The mic wire on my W&W AR4201 harness was on pin 18. If you want to move it to pin 5, unsolder it from 18, move it to 5, and solder it. Pin-outs are in the manual. Thanks. That seems simple enough. It raises a related question though: the mic is a dynamic un-amplified mic (Peiker TM170). If I understand things correctly, the way the harness is currently wired (pin 18) would be for a standard, not a dynamic mic. Why would they do that? The Becker mic is a dynamic mic, as is the Peiker. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Becker AR4201 | John Williams | Soaring | 3 | August 12th 17 03:09 PM |
Becker AR4201 | Robin Birch[_2_] | Soaring | 0 | April 21st 14 06:22 PM |
Becker AR4201 | Robin Birch[_2_] | Soaring | 0 | April 21st 14 05:11 PM |
BECKER AR4201 | guts | Soaring | 1 | April 23rd 12 08:50 PM |
VHF Becker AR4201 | Philippe | Home Built | 2 | July 9th 04 08:30 PM |