|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
March 13th 05, 05:12 PM
|
|||
|
|||
Love to. You got my address?
Jim "George A. Graham" wrote in message ... Jim, I have a Memsic demo board, which displays LEDS on two axis with their tilt and motion sensor. I am done with it, would you like to play with it? George Graham RX-7 Powered Graham-EZ, N4449E Homepage http://bfn.org/~ca266 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vibration Monitor (Hyde, Wanttaja?) | RST Engineering | Home Built | 71 | April 4th 05 04:44 PM |
| Pinging Ron Wanttaja - "Unporting?" | Bob Chilcoat | Home Built | 13 | November 24th 04 07:28 PM |
| Vibration Testing | Jim Weir | Home Built | 20 | October 10th 04 07:22 AM |
| Vibration Testing | Jim Weir | Owning | 21 | October 10th 04 07:22 AM |
| Survey - 3 blade prop conversion- Cockpit vibration, happy or not | Fly | Owning | 20 | June 30th 04 05:32 PM |
Threaded Mode