|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 7th 07, 10:05 PM
posted to rec.aviation.owning
|
|||
|
|||
Any tricks to forming an inner sleeve?
I'm practicing a splice of streamlined tube by inner sleeve.
I'm splitting some of the original tubing to reduce it's diameter. Any tricks to making this easier? Anyway to ease the attempts to form the inner sleeve? - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Navman GPS sleeve | Oscar Goudriaan | Soaring | 1 | March 2nd 07 09:27 PM |
| Forming finger straps. | Mike | Restoration | 7 | April 16th 06 03:53 AM |
| Tech: Aluminum Forming Question | Scott Rodriguez | Home Built | 5 | March 15th 06 04:42 AM |
| Forming Company Veteran Associations | Otis Willie | Naval Aviation | 0 | August 29th 04 05:57 AM |
| Forming Company Veteran Associations | Otis Willie | Military Aviation | 0 | August 29th 04 05:57 AM |
Linear Mode
