If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Refinishing Ventus b Fuselage
On Saturday, December 1, 2018 at 6:52:02 PM UTC-8, Darryl Ramm wrote:
On Saturday, December 1, 2018 at 4:14:07 PM UTC-8, Richard Pfiffner wrote: On Saturday, December 1, 2018 at 1:57:51 PM UTC-8, Charlie Quebec wrote: Ain’t that the truth Mark M, just finished sanding and buffing my DG200-17C all over, about 50 hours to get the original Schaballac gelcoat back to looking new, not bad for a glider made in 1980 to still have original gel in perfect condition. All the work and you have drip. What to do? http://www.craggyaero.com/ventus.htm Richard www.craggyaero.com Stop painting and deal with installing an ADS-B Out system. The change will make sanding seem pleasurable. :-) Installed one two weeks ago in a MinLak FES it was a lot easier than sanding. Richard |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
refinishing Ventus 2cm- wing profile | [email protected] | Soaring | 20 | November 6th 11 12:15 AM |
refinishing | Stig Pedersen | Soaring | 1 | November 27th 05 04:50 PM |
refinishing | Stig Pedersen | Soaring | 1 | November 26th 05 09:16 PM |
Second speaker in Ventus 2b/c fuselage | [email protected] | Soaring | 3 | September 14th 05 05:41 PM |
REFINISHING | Ventus B | Soaring | 32 | December 3rd 03 10:14 PM |