|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#13
May 17th 19, 06:06 PM
posted to rec.aviation.soaring
|
|||
|
|||
Rudder pedal S-tubes
On Thursday, May 16, 2019 at 2:08:10 PM UTC-7, wrote:
On Thursday, May 16, 2019 at 12:48:55 PM UTC-4, Jj wrote: Changing the length of cables is far from questioning the manufacturers design. It is altering it without acceptable or approved data. It's actually not all that critical in this type of installation. Many ships have provisions for such an adjustment. Cable tension, which is part of the flutter prevention element, is done by the springs that pull directly on the pedals. FWIW UH Looked at this while inspecting the Duo (original, same fuselage as Janus Ce) rudder cables in the shop. It would definitely make the back seat more comfortable. Full rudder deflection and "feet off" cable tension would be unaffected, but the tension springs may rub on the composite spring covers after adding a link. Jim 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Antares rudder pedal dimensions | sisu1a | Soaring | 1 | March 22nd 18 04:38 PM |
| Discus Rudder Pedal Adjustment | [email protected] | Soaring | 3 | February 26th 16 05:11 PM |
| rudder pedal springs | Dick[_1_] | Home Built | 6 | May 20th 08 07:23 PM |
| Need Grob 103 Twin II left front rudder pedal | Mike McCarron | Soaring | 1 | May 15th 06 02:16 PM |
| Piper Rudder Pedal Pads | Mike Spera | Owning | 1 | November 4th 05 03:31 AM |
Threaded Mode