If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Minimum bending radius for 0.050" 6061-T6?
I scored some of the above sheet. I need to fabricate an approach plate
holder for my GPS yoke mount. Any idea if T6 will bend without cracking? If so, what minimum bending radius should I aim for to avoid cracks? -- Bob (Chief Pilot, White Knuckle Airways) |
Thread Tools | |
Display Modes | |
|
|