If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Instrument mounting question
I'm looking for some guidance on safely mounting instruments in an alumimium
panel. Our panel is about 2mm (about 1/12th inch) thick. We had all the shapes laser cut, so everything fits well. What do most of you do with deep, heavy instruments like a gyro? Is it safe to just use the screws on the front or do most of you add some form of support at the back of the instrument to support the weight? If so, what construction did you use? Thanks, Rob |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Instrument Question | Dick | Home Built | 10 | May 30th 04 12:05 AM |
Question | Charles S | Home Built | 4 | April 5th 04 09:10 PM |
Aluminum instrument panel finish? | Richard Riley | Home Built | 31 | February 4th 04 02:09 AM |
Question for Squirrel the Lurker | jls | Home Built | 0 | January 30th 04 02:41 PM |
Tecumseh Engine Mounting Question | jlauer | Home Built | 7 | November 16th 03 01:51 AM |