A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Home Built
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Minimum bending radius for 0.050" 6061-T6?



 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old February 3rd 04, 10:20 PM
Bob Chilcoat
external usenet poster
 
Posts: n/a
Default Minimum bending radius for 0.050" 6061-T6?

I scored some of the above sheet. I need to fabricate an approach plate
holder for my GPS yoke mount. Any idea if T6 will bend without cracking?
If so, what minimum bending radius should I aim for to avoid cracks?

--
Bob (Chief Pilot, White Knuckle Airways)



 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 02:42 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AviationBanter.
The comments are property of their posters.