![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#2
|
|||
|
|||
![]()
Top row of pins are odd #s 1 to 23 right to left. Bottom row are even
#s 2 to 22 right to left. PIN 3 Remote IDENT Sw 5 Remote IDENT Sw 9 Switched A+ OUT (+LV) 2 GND 11 MODE C COMMON 14 A1 13 A2 15 A4 19 B1 17 B2 16 B4 21 C1 18 C2 20 C4 10 D4 22 A+ INPUT 12 LIGHTING 1 GND 23 PWR JUMPER 8 PWR JUMPER For 14 VDC operation, connect pins 8 and 23. For 28 VDC operation, connect dropping resistor between pins 8 and 23. Hope this helps, Steve Lars wrote: Anyone out there who knows the pinout of the rear connector of the ARC RT-359A transponder? We just got an altitude encoder to go with the unit (an ACK A-30) in hope for a little better reception from the ATC when flying in controlled airspace... The ACK installation manual is fine, giving the pin numbers to connect, but I don't have the RT-359A manual so I don't know which pin is which. The connector on the back side of the RT-359A is two staggerd rows of flat pins, the top one with 12 pins and the bottom one with 11 pins. There is also two round alignment pins, one on each side of the bottom row. I haven't got the mounting bracket with the female connector out yet, maybe the pin numbers are printed on that one, but it is in a rather awquard place so I don't want to start ripping things apart until i know how to finish the job. BTW, the X-ponder is in a Jodel D119, SE-XED. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transponder requirement confusion | [email protected] | Owning | 24 | August 17th 06 04:16 PM |
My "stupid" transponder question now... | Chris G. | Piloting | 25 | September 20th 05 04:13 PM |
Another stupid transponder question | Jay Honeck | Piloting | 21 | September 17th 05 02:50 AM |
Stupid transponder question, or, stumped by the wife | John Kirksey | Piloting | 35 | September 15th 05 02:44 PM |
transponder check? | Russell Duffy | Home Built | 10 | August 14th 03 11:36 PM |