If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#14
|
|||
|
|||
Pawnee air-oil bear strut pressure
On Monday, April 5, 2021 at 9:19:48 PM UTC-4, Larry Ruggiero wrote:
On Monday, April 5, 2021 at 3:54:26 PM UTC-4, wrote: On Monday, April 5, 2021 at 2:23:07 PM UTC-4, Larry Ruggiero wrote: On Monday, April 5, 2021 at 2:11:19 PM UTC-4, Larry Ruggiero wrote: On Tuesday, March 9, 2021 at 8:24:22 AM UTC-5, wrote: On Monday, March 5, 2018 at 9:37:44 PM UTC-5, Charles Longley wrote: OK I give up. What part are you talking about? Charlie Pilot/ A&P Larry, all you need to do is call Dan at Aerial Banners in Ft. Lauderdale, Florida. Dan is the most knowledgeable person around concerning Pawnee's, he operates about 60 of them and his rebuild shop is impressive. Tell him that I sent you, he will be the best contact available for Pawnee information. Bob Thanks all. To close this out, I just finished overhauling its left strut with new O-rings and backup rings, and it’s fairly straightforward, although the fact that it’s now weeping 5606 out the bottom weep hole tells me that its days are numbered and we’ll probably convert to the hydrosorb/bungee struts after this season. Also the carb airbox wasn’t as worn as I thought and just needed new rubber bushings, which took awhile to get. Btw, the person referenced at Aerial Banners never returned my call. Larry Ruggiero, A&P/IA Carolina Soaring Association I would convert that back to the hydrosorb/bungee configuration whenever you can. If you convert back you can alter the bungee cords used and go to two cords vs three for a much more docile landing bounce. I did this on all of my Pawnee's and it works well. not having 135 gallons of chemical makes a big difference. I might just have a \n old set of hydrosorbs in my stockpile. Bob Bob thanks, would be great to buy them used— they’re pricey new, assuming they’re available at Univair as advertised. Larry Larry, when you get ready let me know and I more than likely can help you out. Yes, they are pricey, way too pricey for what we need. Bob |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
To Pawnee or not to Pawnee...that is the question... | Travis Beach | Soaring | 56 | March 24th 14 06:21 AM |
To Pawnee or not to Pawnee...that is the question... | Travis Beach | Soaring | 4 | October 17th 07 01:31 PM |
Granville's Strut Seal - Or Other Strut Maintenance Techniques | zatatime | Owning | 4 | August 31st 05 04:30 PM |
Cherokee Strut Lower Strut Seal Replacement Report | Mike Spera | Owning | 3 | July 23rd 05 07:07 PM |
High Oil Pressure (was: Low oil pressure, high oil temp?) | Thomas Ploch | Owning | 4 | October 5th 04 04:34 AM |